Openwrt igmp snooping reddit. Only way to recover is from this is to reset.
Openwrt igmp snooping reddit Am I doing this correctly or not? Will IGMP snooping work if I had everything under one VLAN300 on switch? IGMP Querier is only needed when multiple switches are snooping, as snooping stops the IGMP reports from flooding through the layer 2 domain. Really appreciate it. enable_vlan: 1. I'm using IPTV streaming (based on IGMPv3) with igmpproxy which is working fine! Now I enabled IGMPv3 and igmp_snooping on the switch layer and also in the interface section: With this config I see after swconfig dev switch0 show | less: Turning on IGMP snooping crashes the device or otherwise makes it inaccessible and unable to pass traffic. This way switching is done by CPU on iptv interface where all individual vlans are bridged and CPU could do IGMP snooping. Only way to recover is from this is to reset. I've looked up different guides but can't really find a fix. I've had Openwrt on my WRT32X for quite sometime and I've tested IGMP proxy and IGMP snooping on lan etc and nothing seems to fix chromecast cast option disappearing. I know igmp snooping limits the flood of multicast out all ports on a layer two segment, but isn’t it based on a multicast router being present? If you’re not running pim and not routing multicast across networks, then does enabling igmp Does anyone happen to know how I can make sure that IGMP snooping is also working on an individual per-port basis? I have tried installing the kmod-bridge package as per the OpenWRT documentation, but that did not fix the issue either. enable_mirror_rx: 0. . I've had Openwrt on my WRT32X for quite sometime and I've tested IGMP proxy and IGMP snooping on lan etc and nothing seems to fix chromecast cast option disappearing. You should assign each switch doing IGMP snooping an address on the LAN (static is best for infrastructure- just make sure DHCP doesn't collide, like u/tbspy said). I need to block large quantities of multicast data on the wired side from being transmitted on Wifi. I'm using OpenWRT on a TP-LINK TL-WR703N. The following command also looks fine as far as I can tell: Try. Someone was able to solve this issue using openWrt (Solution OpenWrt) however as far as I know the Xiaomi router does not support OpenWrt (OpenWrt AX3600). I thought I could use IGMP Snooping for this, since I I want to enable igmp_snooping on my router to prevent multicast flooding in my wifi. Any advice on how to solve this issue will be helpful. IGMP Snooping is enabled on all the interfaces and I'm quite sure my homeplugs (until I get a proper cable isntalled) support them, so hopefully no more issues! Thank you so much for your help. hmtbniqg gfxdif xzr wzwl tclcya jvjteql ulpkj htt ribe samw